Konica Minolta bizhub C650 - Manual (Page 290)

C650 5-3
Scan function troubleshooting 5
5.2 Network error message list
If an error message appears, perform the corresponding operation described below.
Message Cause and remedy
Cannot connect to the network. A connection to the network could not be established. Check if the net-
work cable is correctly connected. In addition, check that the Network
Settings parameters in Administrator mode have been correctly speci-
fied.
The destination cannot be selected be-
cause the number of destinations has ex-
ceeded the max. number of broadcasting
possible. The number of destinations specified exceeds the number possible for a
broadcast transmission. Reduce the number of broadcast destinations,
or send the transmission in multiple batches.
Image could not be saved in the User Box
due to insufficient HDD capacity. Check
log. The hard disk is full. Delete unnecessary data, and then try saving the
data again.
The number of User Boxes has reached its
maximum. The number of user boxes that can be registered has reached the maxi-
mum number possible. Delete unnecessary user boxes, and then try reg-
istering new boxes again.
This user box has reached its maximum
number of pages allowed. The number of documents that can be saved in a user box has reached
the maximum number possible. Delete unnecessary documents, and
then try saving the document again.
The number of programmed jobs has
reached the max. allowance. Wait until a
programmed job is completed. The number of jobs that can be programmed has reached the maximum
number possible. Wait until a job has been completed, or delete a current
job.