Konica Minolta bizhub C650 - Manual (Page 192)

C650 4-12
Network Settings 4
4.3 TCP/IP Settings
Settings can be specified in order to use this machine in a TCP/IP network environment.
2
Reminder
In order apply all changes to the network settings, this machine must be turned off, then on again.
When the machine is turned off, then on again with the main power switch, wait at least 10 seconds to
turn on the machine after turning it off; otherwise, the machine may not function correctly.
!
Detail
If "DHCP Settings" is set to "ON", [IP Address], [Subnet Mask] and [Default Gateway] are not available.
When a DHCP server is used, the IP address, subnet mask and default gateway are automatically
assigned by the DHCP server; therefore, it is not necessary to assign them manually. However, note the
following points.
Check with the network administrator that the DHCP server is available. If a DHCP server is not
available, be sure to specify settings for "IP Address", "Subnet Mask" and "Default Gateway".
If the IP address and other settings have been assigned by the DHCP server, they may automatically
be changed. If this happens, it may no longer be possible to specify this machine on the network by its
IP address. If "DHCP Settings" is set to "ON", it is recommended that the IP address assigned to the
machine be fixed by configuring the DHCP server.
For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 3-5.
2
Note
To exit Utility mode, press the [Utility/Counter] key or the [Reset] key.
Displaying the TCP/IP Settings screen
1
Touch [5 Network Setting] in the Administrator Settings screen.
2
Touch [1 TCP/IP Settings] in the Network Settings screen.
3
Touch [ON].