Konica Minolta bizhub C350 - Manual (Page 13)

2.1 Admin. Mode authentication function 2
bizhub C350 2-3
A
d
mi
ni
st
ra
to
r O
p
er
at
io
n
s
Ch
apte
r 2
3 Using the 10-Key Pad, enter
the 8-digit Administrator
Code.
4 Touch [Enter].
✎
Note
If the Administrator Code was incorrectly entered, the message
“Administrator Code is incorrect.” appears. Follow the instructions in the
message that appears and type in the correct Administrator Code.
If the Unauthorized Access Lock function is set to “Enable”, incorrectly
entering the Administrator Code is counted as a failed authentication
attempt. If the Administrator Code is incorrectly entered three times, the
message “Access denied due to unauthorized access. Cannot enter
Administrator Mode.” appears after the fourth failed authentication attempt,
and the Administrator Code can no longer be entered. To again allow
access, turn the machine off, then on again.
Make sure that none of the general users of the machine will know the
Administrator Code.
If the Administrator Code is lost, contact your technical representative to
initialize the machine. In addition, after the machine is initialized, the
Administrator Code must be set again.
If PageScope Web Connection has been used to log on to Admin. Mode, the
message “This mode cannot be used due to remote operation. DO NOT turn
off main switch.” appears. Wait a while, and then try accessing Admin. Mode
again.
If Admin. Mode was accessed while the BOX Utility is being used to backup
or restore, the message “This mode cannot be used due to remote
operation. DO NOT turn off main switch.” appears. Wait a while, and then try
accessing Admin. Mode again.