Check dest. & send, Select line, 20 communication settings - e-mail settings – Konica Minolta BIZHUB C652DS User Manual
Page 159: E-mail settings, Document name, Check dest. & send -54 select line -54, Send (p. 7-54, P. 7-54)
bizhub C652/C652DS/C552/C552DS/C452
7-54
7.6
Send (Public, Personal, or Group User Box)
7
Check Dest. & Send
The specified fax number is compared with the remote fax number (CSI) and data is sent only when those
fax numbers match. If they do not match, the communication will fail; therefore preventing a sending error.
Reference
-
To use the Check Dest. & Send, you must register the local fax number in the remote machine in
advance.
Select Line
You can specify [Line 1] or [Line 2] for sending data when two fax kits are installed. Specify the line used for
transmission. If you select "Not Set", either Line 1 or Line 2 whichever is not busy is used for transmission. If
both lines are idle, Line 1 is used first.
Reference
-
You cannot specify a line when "Line 2 Setting" is set to "RX Only" in "Multi Line Usage". For details on
the Multi Line Usage function, refer to the "User's Guide [Network Scan/Fax/Network Fax Operations]".
-
To use two lines as external and extension lines, be sure to specify the line to be used. If you select
"Not Set", a sending failure may occur.
7.6.20
Communication Settings - E-Mail Settings
E-mail Settings
Specify the document name, subject, From address and message body for sending e-mail messages.
Document Name
The name of the file to be saved is displayed. This document name can also be specified in the [File
Document] screen. The document name whichever is specified later will be applied to this column. You can
enter up to 30 characters.