Konica Minolta BIZHUB C652DS - Manual (Page 158)

bizhub C652/C652DS/C552/C552DS/C452 7-53
7.6 Send (Public, Personal, or Group User Box) 7
7.6.19 Communication Settings - Line Setting
Description of Line Settings
Configure line settings for fax transmission.
Overseas TX
Faxes are sent to locations with poor communication conditions at a lower baud rate.
Reference
- This function cannot be used together with the following functions.
– Polling transmission
– Polling reception
– Bulletin board
ECM OFF
The Error Correction Mode (ECM) is turned off when sending data. ECM is an error correction mode defined
by ITU-T (International Telecommunication Union - Telecommunication Standardization Sector). Fax
machines equipped with the ECM feature communicate with each other, confirming that the data sent is free
of errors. Thus, communication can be made free from disturbances due to line noises, etc. If noises
frequently occur, it may take a slightly long time to complete a communication compared with ECM OFF.
After sending has been ended, this machine automatically returns to ECM ON.
Reference
- This machine sends faxes in ECM ON unless ECM OFF is specified.
- This function cannot be used together with the following functions.
– Polling RX
– Polling TX
– V.34 OFF
– Bulletin board registration
– Bulletin board polling reception
V.34 OFF
V34 is a communication mode used for super G3 fax communication. When the remote machine or this
machine is connected to a telephone line via PBX, however, you may not establish a communication in the
super G3 mode depending on telephone line conditions. In this case, it is recommended that you turn V34
off to send data. After sending has been completed, this machine automatically returns to the V34 mode.
Reference
- This function cannot be used together with the following functions.
– Polling RX
– Polling transmission
– Bulletin board registration
– Bulletin board polling reception
– ECM OFF