Konica Minolta bizhub 42 - Manual (Page 22)

bizhub 42/36 3-4
3.2 Basic copy operations 3
% The original must be set in w direction towards the direction for loading the paper.
3
Slide the adjustable Lateral Guide against the edges of the original.
Placing the original on the Original Glass
0 Do not place an original weighing more than 6-5/8 lb (3 kg) on the Original Glass. Furthermore, do not
use a strong force to press down on a book or any other form of original that must be spread on the
original glass. Otherwise, the machine may be damaged or a failure may occur.
0 For thick books or large objects, perform scanning without closing the ADF. When a original is being
scanned with the ADF open, do not look directly at the Original Glass surface where light may be emit-
ted through. Note, however, that the light coming through the original glass is not a laser beam, and will
not expose the user to the related hazards.
1
Lift open the ADF.
2
Place the original face down on the Original Glass.
% Load the original by placing it so that its head (top side) faces
the left.
3
Align the original with the mark in the back-left corner of the
Original Scale.
% For transparent or translucent originals, place a blank sheet of
paper of the same size as the original over the original.
% For bound originals spread over two facing pages, such as a
book or a magazine, position the top of the original toward the back of this machine and align the
original with the
mark in the back-left corner of the Original Scale.
% If the original is loaded in any orientation other than with the head (top) of the original toward the
left, be sure to select the original orientation.
4
Close the ADF.
3.2.2 Basic copy operations
The following procedure describes the basic copy operations. (Copy with 1>1 and Full Size)
0 This machine cannot automatically detect the size of an original document that will be scanned. Before
scanning the document, specify its size. If the size of the original document is not correctly specified,
some parts of the image may be lost. For details on specifying the size of an original document, refer
to page 5-3.
1
Arrange originals in the order you want them to be scanned and
load them face up in the ADF.
% The original should be placed face down on the Original
Glass.
2
Press [Copy] or the Copy key.
% When the Start key is pressed in the home screen, one sheet can be copied by setting the "Copy
Initial Setting".
3
Using the Keypad, enter a value for the number of copies you desire.
% If you have entered incorrect number of copies, press the C (clear) key on the keypad, and then re-
enter the correct number.