Konica Minolta bizhub 42 - Manual (Page 87)

bizhub 42/36 8-7
8.2 Troubleshooting table 8
[Total counter by user has
reached the limit.] The limit on the number of pages
that can be printed has been
reached. Contact the administrator of the
machine.
[Total counter by account
reached the limit.]
[Cover Open]
[Cover is open.
Close all covers properly.] Since a machine door or cover is
open or an option is not installed
correctly, the machine is unable
to make copies. Make sure that all doors and
covers of this machine and op-
tions are closed securely.
[ADF Initialize Error]
[Open and close ADF cover.] The ADF cover is not securely
set. Open the ADF cover, and close it
again.
[Toner is low]
[Prepare new toner bottle.] The toner is about to run out. Prepare a spare Toner Bottle for
replacement following the guid-
ance contained in your mainte-
nance agreement.
[Replace toner]
[Replace toner by following the
instruction and close front door.] Toner is depleted. Replace the Toner Bottle follow-
ing the guidance contained in
your maintenance agreement.
[Imaging Unit Missing]
[Drum and Developing Unit is
not set.] The imaging unit is not properly
set. Contact your service representa-
tive.
[Replace Staples]
[Replace the staple cartridge.] The staples have run out. Replace the Staple Cartridge.
[Exceeds the no. of pages being
stapled.]
[Exceeds the number of pages
that can be stapled. Cancel sta-
pling.] The number of printed pages ex-
ceeds the maximum number of
pages that can be stapled. Terminate the job.
[Misfeed Detected]
[Misfeed was detected.
Remove the paper.] Since a paper jam occurred, the
machine is unable to make cop-
ies. Clear the jammed paper.
[Reset Originals]
[Reset the following number of
originals
xxx] After clearing a paper jam, it is
necessary to reload certain pag-
es of the original that have al-
ready been fed through the ADF. Load the indicated original pages
into the ADF.
[Job Registration Limit Over]
[Registered jobs reached limit.
Wait for job registration to com-
plete.] Copy, scan or fax transmission
operations were repeated while
printing or transmissions could
not be performed. Wait a while. The error is can-
celed.
[Locked due to failed access at-
tempts. Contact the administra-
tor.] The authentication information
has become invalid since the au-
thentication attempts have failed
the specified number of times. Turn the machine off, then on
again.
Turn off the Power Switch, and
then wait at least 10 seconds be-
fore turning it on again.
The administrator password has
become invalid since the authen-
tication attempts have failed the
specified number of times.
[Service Call]
[Error occurred. Power OFF and
ON, or contact Service with
Trouble Code; xxx] The machine malfunctioned and
is unable to make copies. Take a remedy according to the
message displayed in the
screen. If the problem is not re-
solved or released, inform your
service representative of the
malfunction code displayed in
the screen.
When the message that
prompts the replacement of the
following consumables:
•
Drum Unit
• Fusing Unit
• Developing Unit
• Developer
Consumables need replace-
ment. Or consumables have
been used beyond the specified
period. Contact your service representa-
tive.
Message Cause Remedy