Konica Minolta Printgroove - Manual (Page 204)

Drawing Image and Placing Object 6
Printgroove POD Ready 6-24
of the selected object displayed in the [Page Area] to the range you
want to change.
– Width: You can resize the width of the selected object. This value is
always synchronized with current width of the object.
– Height: You can resize the height of the selected object. This value
is always synchronized with current height of the object.
– Keep the current aspect ratio: You can keep the current aspect ra-
tio. When you resize the one value of width or height, the other val-
ue will be automatically entered with the same aspect ratio of the
current selected object. If the height of the object is changed, the
width is also changed in relation to the original aspect ratio, and
vice versa. Default value will be “off”. Aspect ratio that this setting
is changed from “off” to “on” is maintained.
– To make the horizontal to vertical ratio identical:
Drugging the cursor with the [Shift] key pressed allows you to draw
a figure the horizontal and vertical ratio of which is identical.
6
If necessary, change the position of the circle selected using [Circle]
property displayed in [Property Panel] or drag the selected object to the
position to move.
– Right Top: You can select the origin of the selected object as Left-
Top corner of the page.
– Left Top: You can select the origin of the selected object as Left-
Top corner of the page.
– Width: You can specify the width from the specified origin above.
This value is always synchronized with the value of current position
of the selected object. When you click [Horizontal Centering], suit-
able value is inputted in [Width] and then you can make the object
centered horizontally.
– Height: You can specify the height from the specified origin above.
This value is always synchronized with the value of current position
of the selected object. When you click [Vertical Centering], suitable
value is inputted in [Height] and then you can make the object cen-
tered vertically.
7
Click [OK] of [Property Panel].
All the values in [Property Panel] are fixed.