Konica Minolta Printgroove - Manual (Page 220)

Drawing Image and Placing Object 6
Printgroove POD Ready 6-40
6.13.3 Paste
You can paste the following items in Printgroove POD Ready memory in the
cursor position of the page area.
-
Printgroove POD Ready Object(s)
- Contents of a raster rectangle selection
When raster rectangle is pasted on raster PDF page then the image should
be extracted from the PDF then the raster rectangle should be merged with
the image to perform paste operation.
When the raster rectangle is pasted on a non raster page it should pasted a
new Printgroove POD Ready image object.
2
Note
– The operation for the raster rectangle is handled by using the clip-
board memory.
– If you copy any object in the current page and paste it onto the
same page, the object is pasted near the copied object. But, if the
object is pasted to other page(s), the object is pasted on the same
position as original Page to other Page.
– For Perfect Binder Cover sheet or Uneditable sheet, Cut, Copy and
Paste operation cannot be performed for these pages.
To paste item(s), follow these steps:
1
Move the cursor position of the page area where you want to paste.
2
Select [Edit] - [Paste] menu.
The selected item is pasted.
6.13.4 Duplicate
You can duplicate the selected Printgroove POD Ready object near the par-
ent object.
Duplicate operations will copy and paste the selected object. It will not store
in the clip board memory after duplicate operations.
2
Note
– About the detail of Printgroove POD Ready objects, please refer to
“Printgroove POD Ready Object” on page 3-12.
To duplicate object(s), follow these steps:
1
Select the object(s) which you want to duplicate.