Pioneer DJM-800 - Manual (Page 6)

6
<DRB1392>
En
POWER
MASTER 2 REC
R L
R
(TRS)
L MASTER 1
L
R
PHONO
CONTROL
DIGITAL
MIC SIGNAL
CUT ADD
SIGNAL GND SIGNAL GND
LINE
DIGITAL
LINE
DIGITAL
CD
DIGITAL
CD
LINE
L
R
AC IN
OFF ON
1GND
3COLD
MASTER ATT
2HOT
PHONO
CONTROL
BOOTH R L (MONO) SEND
R L (MONO)
RETURN
LINE
L
R
PHONO
CONTROL
CD
L
R
LINE
CONTROL
DIGITAL OUT
MIDI OUT
fs (Hz)
48 k 96 k
CD
L
R
-12dB
-6dB
-3dB 0dB
DIGITAL IN
L R L R
CONNECTING EXTERNAL EFFECTORS, OUTPUT CONNECTORS
Master output
This unit is furnished with balanced output MASTER 1 (supporting
XLR plugs), and unbalanced output MASTER 2 (supporting RCA
plugs).
Using the MASTER ATT switch, adjust the output level to match the
input sensitivity of the power amplifier used.
If the operating panel’s STEREO/MONO switch is set to [MONO], the
master output will be a monaural combination of L+R channels.
Booth monitor output
This is a TRS output supporting Ø6.3 mm phone plugs. The sound
volume for this output is controlled by the BOOTH MONITOR level
dial, independently of the master output level setting.
Recording output
These are output connectors for recording, supporting RCA plugs.
ABOUT MIDI CONNECTORS
See P. 19 regarding the functions of MIDI connectors.
Power amplifier
(RCA plug input connectors)
Cassette deck
(analog input recording device)
Digital input AV amplifier
(digital input recording device)
External effector Power amplifier
(XLR plug input connectors)
MASTER ATT
switch
Power amplifier
(for booth monitor)
Digital output
This is a coaxial digital output connector, supporting RCA plugs. The
sampling frequency can be set to 96 kHz/24-bit or 48 kHz/24-bit to
match the connected device.
External effector
Use a cable with Ø6.3 mm phone plugs to connect the DJ mixer’s
SEND connectors to the effector’s input connectors.
When using an effector with monaural inputs, connect only to the DJ
mixer’s L channel output. In this way, the mixed L+R audio signal will
be sent to the effector. In the same way, use a cable with Ø6.3 mm
phone plugs to connect the DJ mixer’s RETURN connectors to the
output connectors of the effector.
If the effector has only monaural output, connect to the DJ mixer’s L
channel input only. The signal from the effector will be input to both L
and R channels.
When using an external effector, set the effect selector to [SND/RTN].
Sampling frequency selector switch
CONNECTIONS (CONNECTING EXTERNAL EFFECTORS, OUTPUT CONNECTORS/ABOUT MIDI CONNECTORS)