Pioneer PDP-LX5090H - Manual (Page 25)

Watching TV 06
25
En
E
n
glish
Note
• In each of the sound multiplex mode selected using the -
button, the display changes depending on broadcasting signals
being received.
• Once the MONO mode is selected, the sound remains mono
even if the system receives a stereo broadcast. You must switch
the mode back to
 or  mode if you want to hear stereo sound
again.
• Selecting a sound multiplex mode while the input source is
“INPUT 1” to “INPUT 5” does not change the type of sound. In
this case, sound is determined by the video source.
• For DTV broadcasts, the language you hear immediately after
channel selection depends on the language setting (“Primary
Audio” or “Secondary Audio”) in
Selecting languages for audio,
subtitles, and teletext on page 47. In some cases, the selected
language may differ from that displayed on screen.
Switching an audio component
The TOOLS Menu also allows selecting from up to 32 audio
components.
1 Press TOOLS.
2 Select “Audio” ( /).
3 Select the desired audio component ( /).
You can switch:
– an audio component between the languages (digital
broadcast only)
– an audio component for the Home Media Gallery (page 69)
Using the multiscreen functions
• Before operating with the remote control unit, make sure to select
the TV mode using its SELECT button. See Controlling other
equipment using the supplied remote control unit on page 86.
Splitting the screen
Use the following procedure to select 2-screen or picture-in-picture
mode.
Note
• Displaying a split screen for a long period of time, or for shorter
periods of time everyday, may result in image retention.
1 Press c to select the display mode.
Each time you press c, the display mode is switched among 2-
screen, picture-in-picture, and single-screen.
2-screen
Picture-in-picture
Main screen Sub screen
Main screen Sub screen
PDP-LX609H.book Page 25 Wednesday, August 6, 2008 4:00 PM