Toshiba Magnia 7100 - Manual (Page 50)

42 Setup
After Installation (Windows NT 4.0)
After Installation
(Windows NT 4.0)
If Windows NT Server 4.0 installation is complete, follow the procedure given below.
1. Start Windows NT Server 4.0 and logon as the Administrator (or as a user having
equivalent access).
2. Run Date/Time Properties by clicking Start, Settings, Control panel, and double clicking
Date/Time.
3. Click Time Zone tab.
4. Check that the current Time Zone setting is correct. If incorrect, select the correct setting
and press [Ok].
Selecting the display driver
To display in SVGA mode or above , the video driver from the retail driver included in
the Windows NT CD-ROM to the video driver included in the SST CD-ROM must be
changed. Before changing the display driver, the Windows NT Service Pack (version
higher than Service pack 4) must be installed. To install the Windows NT Service
Pack, follow you’re the installation instructions given in the MAGNIA 7100 User's
Guide..
On completion of the Windows NT Service Pack installation, follow the steps below.
1. Start Windows NT Server 4.0, and log in using the Administrator ID or a User ID
having equivalent rights.
2. Run Display Properties from Windows NT, by clicking Start, Settings, Control
panel, and double-clicking Display.
3. Select the Settings tab, click Display Type, and then click Change.
4. Insert the Toshiba 'Server Setup TooL' CD-ROM, and select Have disk. Enter the
following path:
<CD-ROM>\PUBLIC\VIDEO\ATI\RAGE2C\NT
Select "ATI Rage IIC".
5. When the following message appears, select Yes.
You are about to install a third-party driver.
This driver was written by the hardware vendor, and is only provided here as a convenience.
For any problem with this driver, please contact the hardware vendor.
6. After copying files, restart the Windows NT Server 4.0 before making any changes
to the setting.
7. After log-in to the system, the 'Display Properties Dialog' is opened. Set the desired
display mode in the dialog, and then press OK.