Toshiba Magnia 7100 - Manual (Page 63)

51
HW Diagnostics
Starting from the Utility Partition
Starting from the Utility Partition
1. Switch on the server.
When the system reboots, the following message appears; press <Ctrl> + <t>.
2. When the Utility Partition is activated, the following message appears:
Utility Partition is successfully activated.
3. Select "Utility" option from the SST [Main Menu] screen.
4. Select [HW Diagnostics] option.
After the completion of the test, close the 'HW Diagnostics Program'. The Toshiba 'Server
Setup TooL' menu appears again after rebooting.
NOTE: To start the HW Diagnostics Program from the diskette, create the HW Diagnostics Program
diskette from the “Create Floppy Disks” menu in the SST.
SMC BIOS xxx.xx.xxx
©xxxx,TOSHIBA CORPORATION. All Rights Reserved.
Key is accepted. (*)
Input <Ctrl>+<t> keys within four seconds after
the appearance of the message.
NOTE: If disk access fails, the following message appears:
Error detected. Utility Partition is not activated.
If the Utility Partition does not exist, the following message appears:
Utility Partition is not found.
NOTE: To finish the HW Diagnostics Program started from the Utility Partition, select [Main Menu] –
[Exit] of the Server Setup TooL.