Brother PC 3000 - Manual (Page 27)

24
PRESSER FOOT
Changing the presser foot
1. Press the “NEEDLE POSITION” button to raise the needle,
and then turn off the power.
2. Raise the presser foot lever.
3. Press the black button located at the back of the presser foot
holder to release the foot.
1 Presser foot holder
4. Place the presser foot pin directly below the holder-end and
lower the presser foot lever to attach the presser foot.
1 Holder-end
2 Foot pin
Loosen the presser foot holder screw, then pull the presser foot
holder down to remove it.
Note
When reattaching the presser foot holder, first attach the presser
foot to the presser foot holder. Then, lower the presser foot lever,
install the presser foot holder and securely tighten the presser
foot holder screw. The thread tension may be inaccurate if the
presser foot holder is incorrectly attached.
1 Disc-shaped screwdriver
Removing the presser foot holder (while cleaning, etc.)
1
2
1
6
1
5