Brother PC 3000 - Manual (Page 31)

28
1. SEWING CHAPTER 2
TRIAL SEWING
Sewing using a utility stitch
CAUTION
–
Be aware of the needle at all
times while sewing, and keep
your hands away from all
moving parts such as the
needle, balance wheel and
thread take-up lever, otherwise
an injury may result.
– Do not pull or push the fabric
too hard while sewing, otherwise
injury may result.
– Never use bent needles. Such
needles can easily break, which
could result in injury.
1. Turn on the sewing machine. The straight stitch (left) is se-
lected.
3. While pressing down on the thread and the fabric with your
left hand, turn the balance wheel with your right hand to move
the needle to the sewing start position.
1 Thread
* You can begin sewing without drawing up the bobbin thread.
2. Place the fabric under the presser foot, then pull out about 5
cm (2") of the upper thread and pass it under the presser foot
toward the rear of the machine.
1 Upper thread
2 5 cm (2")
1
2
6
1
3
4
5
2