Philips AVENT Vigilabebés DECT - Manual (Page 15)

15
9 Cleaning and
maintenance
B Warning:
Do not immerse the parent unit or the baby unit
in water and do not clean them under the tap.
B Warning:
Do not use cleaning spray or liquid cleaners.
1
Unplug the baby unit if it is connected to the
mains and take the parent unit out of the
charger.
2
Clean the parent unit and the baby unit with a
damp cloth.
B Warning:
Make sure the parent unit is dry before you
put it back into the plugged-in charger.
3
Clean the charger with a dry cloth.
4
Clean the adapters with a dry cloth.
10 Storage
• You can use the travel pouch to store the
baby monitor while you travel.
• When you are not going to use the baby
monitor for some time, remove the non-
rechargeable batteries from the baby unit and
remove the rechargeable battery pack from
the parent unit. Store the parent unit, the baby
unit, the charger of the parent unit and the
adapters in the travel pouch supplied.
7.12.1 Default settings
Parent unit
• Vibration alert: off
• Language: English
• Loudspeaker volume: 1
• Microphone sensitivity: 5
• Sound alert: off
• Temperature alert: off
• ’Temperature low’ alert: 14°C
• ’Temperature high’ alert: 35°C
• Temperature scale: Celsius
• ECO mode: off
Baby unit
• Loudspeaker volume: 3
• Nightlight: off
• Lullaby: off
8 Accessories
8.1 Belt clip and neck strap
If the battery pack of the parent unit is sufficiently
charged, you can take the unit with you inside
and outside the house if you attach the unit to
your belt or waistband with the belt clip or if you
hang it around your neck with the neck strap. This
allows you to monitor your baby while you are
moving around.
8.1.1 Connecting the belt clip
1
Snap the belt clip onto the parent
unit (Fig. 33).
8.1.2 Disconnecting the belt clip
1
Pull the belt clip off the parent unit.
8.1.3 Connecting the neck strap
1
Insert the end loop of the neck strap through
the hole behind the strap post. Thread the
neck strap through the end loop and pull the
neck strap tight (Fig. 34).
8.1.4 Disconnecting the neck strap
1
Pass the neck strip through the end loop and
pull the end loop out of the hole behind the
strap post.
ENGLISH