Barracuda Networks VERSION SP4 - Manual (Page 188)

186 802.1X – Technical Guideline
To enable or disable verbose the below registry needs to be set:
14.2.4 Switch Web Interface
The web interface provides various outputs for monitoring and configuration. These can be viewed in
any web browser. The web interface additionally provides a simple command-line allowing configuring
or showing any settings.
Following sample output shows the 802.1X configuration for the port used in this document.
• Command base-URL:
/level/15/exec/-
• Complete URL:
/level/15/exec/-/show/dot1x/interface/fa0\/3/CR
• Command:
show dot1x interface fa0/3
These values are described in more details on:
Table 14–4 Key Logging
Item Description
Path HKEY_USERS\.Default\Software\phion\phionvpn\settings
Key Logging
Value Enables or disables verbose output to be written (Default=0).
• 0 - disabled
• 1 - enabled
Changing this value takes effect immediately.
This value may also be changed through the
Advanced Settings of the Barracuda NG Access Monitor.
Fig. 14–1 802.1X configuration for the used ports
Supplicant MAC 00a0.c992.0000
AuthSM State = AUTHENTICATED(AUTH-FAIL-VLAN)
BendSM State = IDLE
Posture = N/A
ReAuthPeriod = 3600 Seconds (Locally Configured)
ReAuthAction = Reauthenticate
TimeToNextReauth = 3224 Seconds
PortStatus = AUTHORIZED(AUTH-FAIL-VLAN)
MaxReq = 2
MaxAuthReq = 2
HostMode = Single
PortControl = Auto
ControlDirection = Both
QuietPeriod = 1 Seconds
Re-authentication = Enabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 251
AuthFail-Vlan = 252
AuthFail-Max-Attempts = 3
Critical Port = Disabled