Billion Electric Company BIPAC-741 GE V2.0 - Manual (Page 21)

Billion BIPAC-741 GE V2.0 ADSL Firewall Router
17
If you ever forget the password to log in, you may press the RESET button to restore
the factory default settings..
3.4.2 LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown
below.
LAN Port WAN Port
IP address
192.168.1.254
Subnet Mask
255.255.255.0
DHCP server function
Enabled
IP addresses for
distribution to PCs
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
(Actually, it can support up to 253
users.)
The PPPoE Routed
Mode function is
enabled to automatically
get the WAN port
configuration from the
ISP, but you have to set
the username and
password first.
3.5 Information from the ISP
Before configuring this device, you have to check with your ISP (Internet Service Provider) what
kind of service is provided such as PPPoE, PPPoA, RFC1483, IPoA, or PPTP-to-PPPoA
Relaying.
Gather the information as illustrated in the following table and keep it for reference.
PPPoE
VPI/VCI, VC-based/LLC-based multiplexing, Username,
Password, Service Name, and Domain Name System (DNS)
IP address (it can be automatically assigned from ISP or be
set fixed).
PPPoA
VPI/VCI, VC-based/LLC-based multiplexing, Username,
Password, and Domain Name System (DNS) IP address (it
can be automatically assigned from ISP or be set fixed).
RFC1483 Bridged
VPI/VCI, VC-based/LLC-based multiplexing and configure
this product into BRIDGE Mode.
RFC1483 Routed
VPI/VCI, VC-based/LLC-based multiplexing, IP address,
Subnet mask, Gateway address, and Domain Name System
(DNS) IP address (it is fixed IP address).