Philips DECT Babyphone - Manual (Page 10)

Talking to your baby
(Talk function)
While using the TALK button (B-1) on the parent unit you can
talk to your baby (e.g to comfort your baby).
• Press and hold the TALK button (B-1) and talk clearly into
the microphone (B-5).
• Release TALK button (B-1) when finished talking.
Note:When the TALK button (B-1) is pressed, you can no
longer hear your baby.
Adjusting microphone sensitivity
With the SENSITIVITY (B-2) and Volume + and – (B-10)
buttons on the parent unit, you can set the sound from the
baby unit to the desired level.When set to the maximum level,
the baby unit monitors continuously. All sounds (including your
baby’s breathing, when loud enough) can be heard on the parent
unit.You can only change the microphone sensitivity if the
connection between the baby unit and the parent unit is
established (when LINK lights (A-2, B-8) light continuously
green).
1 Briefly press the SENSITIVITY button (B-2) on the parent
unit.
> The sound-level lights (B-9) give visual feedback on the
current sensitivity level for approximately 2 seconds.
2 Briefly press the Volume + and – buttons (B-10) on the
parent unit to increase/decrease the microphone sensitivity of
the baby unit.
Note: If you press the SENSITIVITY button (B-2) and/or the
Volume + and – buttons (B-10) too long, the microphone
sensitivity will not be adjusted.
> The sound-level lights (B-9) give visual feedback on the new
setting for approximately 2 seconds:
- 1 light (1 x orange) = minimum level / lowest sensitivity;
- all lights (5 x orange) = maximum level (continuous
transmission) / highest sensitivity
Note:When the sensitivity level of the baby unit is set to a high
level, the unit will consume more power because it is in
continuous transmission mode.
EN
10
Other features