Philips DECT Babyphone - Manual (Page 9)

EN
Using your baby monitor
Other features
Adjusting loudspeaker volume
• Briefly press the Volume + and – buttons (A-4) on the baby
unit to increase/decrease the loudspeaker volume of the baby
unit.
• Briefly press the Volume + and – buttons (B-10) on the
parent unit to increase/decrease the loudspeaker volume of
the parent unit.
Notes:
– If you press the Volume + and – buttons (A-4, B-10) too long,
the volume will not be adjusted.
– If the volume is set to a high level, the units consume more
power.
9
> The LINK lights (A-2, B-8) on both units blink green until
connection has been established.This will take up to
approximately 30 seconds. Both LINK lights (A-2, B-8) will
then light green continously.
> If, after 30 seconds, no link is establshed both LINK lights
(A-2, B-8) will light up red and the parent unit will emit a
beep from time to time.
4 Position the baby unit at least 1 meter / 3 feet away from
your baby.
5 Position the parent unit at the desired place within the
operating range of the baby unit but at least 1 meter / 3 feet
away from the baby unit. For more information on the
operating range see ‘Technical specifications’.
➜ You can now monitor your baby!