B&K AVR212 - Manual (Page 31)

27
Speaker Location
Ideally your speakers will be the same distance away from your listening area. However, physical limitations
usually require placing the speaker in other than optimum locations. Your receiver contains a means to
electronically move each speaker’s location. This allows for superior reproduction of the directional cues available
during the playback of movie or music. Measure the distance in feet to your speakers and set each speaker
location setting to this distance. Your receiver will electronically “move” each speaker to maintain correct time
alignment with the listening position. You may also change the units to meters, if you prefer.
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Speaker Location
2 SEL or ENTER (ENTER) activate SPEAKER LOCATION
3 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Left Front
4 ¶ (REW) or • (FF) VOLUME KNOB adjust left speaker location
5 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Center
6 ¶ (REW) or • (FF) VOLUME KNOB adjust center speaker location
7 repeat 5-6 for each speaker repeat 5-6 for each speaker repeat for all speakers
8 MENU MENU return to SETUP SPEAKERS
SETUP SPEAKERS
1 Speaker Size
2 Speaker Location
3 Speaker Levels
4 Crossovers + LFE
5 Room Equalization
next item SEL select
MENU setup system
2 Speaker Location
SPEAKER LOCATION feet
Left Center Right
Front 99.9* 99.9* 99.9*
Surround 99.9 99.9
Back 99.9 99.9
Back Width 99.9
Subwoofer 99.9
next item adjust
MENU speaker setup
Front 99.9* 99.9* 99.9*
SPEAKER LOCATION LEFT Front 99.9