B&K AVR212 - Manual (Page 69)

65
Set surround mode operation - Most users will prefer the factory setting - AUTO. In this mode the receiver
automatically sets the surround mode to full 7.1 channel operation (or as many as permitted by your speaker
setup) whenever a Dolby Digital or DTS bitstream is detected regardless of what surround mode you have
selected. For example, load your CD changer with a normal PCM CD, a DTS CD, and another normal PCM CD
and select audio mode SURROUND 3 (see AUDIO MODES above). While the PCM CD is playing you will get
sound from the front and center speakers only. When the disc changes to the DTS CD you will get sound from all
front, center, and surround speakers. When the third (PCM) CD starts the receiver returns to SURROUND 3. Note
that if a Dolby Digital or DTS source is currently playing and you change the audio mode the receiver will stay in
the selected audio mode until you select another input or turn the receiver off and on. In MANUAL mode the
chosen audio mode remains set regardless of the bitstream detected. In the above example only the front and
center speakers would be used on all three CDs even though the DTS CD was capable of providing full 5-channel
sound to 7.1 speakers. Note that the surround channel information is not lost. It is simply mixed into the front
speakers.
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Surround Modes
2 ¶ (REW) or • (FF) VOLUME KNOB set to Auto or Manual
3 MENU MENU return to ADVANCED SYSTEM SETUP
Zone 2 (B) Setup
Zone B has been factory default set to use a Zone ID setting of 2. Zone 2 (B) configurations will allow you to set
or fix the maximum volume level, remote control ‘Zone’ ID, and V2 tape mode for Zone 2 (B). Additionally, there
are options to set the linking of Zone 2 (B) to Zone 1 (A). Make sure you are in the ADVANCED SYSTEM SETUP
menu and the remote is in B&K mode.
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Screen Display User
4 V1 Output Tape
5 Surround Modes Auto
6 Favorite Recall use ENTER
next item adjust
MENU advanced setup
5 Surround Modes Auto
MODES AUTO
ADVANCED ZONE A SETTINGS
1 Max Level +15 dB
2 Zone ID 1
3 On Screen Display User
4 V1 Output Tape
5 Surround Modes Manual
6 Favorite Recall use ENTER
next item adjust
MENU advanced setup
5 Surround Modes Manual
MODES MANUAL
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Zone 2 (B) Setup
2 SEL or ENTER (ENTER) activate ADVANCED ZONE 2 (B) SETTINGS
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
7 RS-232 Control Port
next item SEL select
MENU setup system
2 Zone 2 Setup 'B'
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Maximum Level +15 dB
3 Zone ID 2
4 V2 Output Tape
5 Link Input to Zone A No
6 Link Power to Zone A No
next item adjust
MENU advanced setup
1 Level Control Variable
Z2 SETUP "B" ZB LVL VARIABLE