Belkin N Wireless Modem Router PM01527ea F5D8636-4 User Manual
Page 37
35
N Wireless Modem Router
sections
table of contents
1
2
3
4
6
7
8
9
10
5
alTeRNaTe seTUP MeTHod
1 . WaN IP address – Enter an IP address assigned by your ISP for the
Router WAN interface .
2 . subnet Mask – Enter a subnet mask assigned by your ISP .
3 . Use static default gateway – Enter a default gateway IP address .
If the Router cannot find the destination address within its local
network, it will forward the packets to the default gateway assigned
by your ISP .
4 . VPI/VCI – Enter your Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI) parameter here . These identifiers are assigned by
your ISP .
5 . encapsulation – Select LLC or VC MUX your ISP uses .
Click “Apply Changes” to save and activate your settings . To go back
to the original settings before saving, click “Clear Changes” . Or click
any of the Quick-Navigation links for other options . Your new settings
will not be saved unless your click “Apply Changes” .
setting your IsP Connection Type to static IP (IPoa)
This connection type is also called “Classical IP over ATM” or “CLIP”, which your ISP provides a fixed IP for your Router to connect to the Internet .