Manually configuring network settings – Belkin N Wireless Modem Router PM01527ea F5D8636-4 User Manual
Page 78
76
N Wireless Modem Router
sections
table of contents
1
2
3
4
5
6
8
9
10
7
MaNUally CoNfIgURINg NeTWoRK seTTINgs
5 . If “Manually” is selected, your Router will need to be set up for a static
IP connection type . Write the address information in the table below .
You will need to enter this information into the Router .
3 . Select “Built-in Ethernet” (2) next to “Show” in the Network menu .
4 . Select the “TCP/IP” tab (3) . Next to “Configure” (4), you should see
“Manually” or “Using DHCP” . If you do not, check the PPPoE tab
(5) to
make sure that “Connect using PPPoE” is NOT selected . If it is, you will
need to configure your Router for a PPPoE connection type using your
user name and password .
6 . If not already selected, select “Using DHCP” next to “Configure” (4),
then click “Apply Now” .
your network settings are now configured for use with the Router .
(2)
(3)
(4)
(5)