Belkin N Wireless Modem Router PM01527ea F5D8636-4 User Manual
Page 54
52
N Wireless Modem Router
sections
table of contents
1
2
3
4
5
7
8
9
10
6
UsINg THe Web-based adVaNCed UseR INTeRfaCe
setting MaC address Control
The MAC address filter is a powerful security feature that allows you to specify which computers are allowed on the wireless network .
Note: This list
applies only to wireless computers . This list can be configured so any computer attempting to access the wireless network that is not specified in the
filter list will be denied access . When you enable this feature, you must enter the MAC address of each client (computer) to which you want to allow
network access . The “Block” feature lets you turn on and off access to the network easily for any computer without having to add and remove the
computer’s MAC address from the list .
setting up an allow access list
1 . Select the “Allow” radio button (1) to begin setting up a list of
computers allowed to connect to the wireless network .
2 . Next, in the “MAC Address” field that is blank (2), type in the MAC
address of the wireless computer you want to be able to access the
wireless network, then click “<<Add”
(3) .
3 . Continue to do this until all of the computers you want to add have
been entered .
4 . Click “Apply Changes” (4) to finish .
(1)
(2)
(3)
(4)