Belkin N Wireless Modem Router PM01527ea F5D8636-4 User Manual
Page 38
36
N Wireless Modem Router
sections
table of contents
1
2
3
4
6
7
8
9
10
5
alTeRNaTe seTUP MeTHod
1 . enable bridge service – Check this box to enable bridge service
2 . VPI/VCI – Enter your Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI) parameters here . (Assigned by your ISP) .
3 . encapsulation – Select the LLC or VC MUX your ISP uses .
Click “Apply Changes” to save and activate your settings . To go back to
the original settings before saving, click “Clear Changes” . Or click any of
the Quick-Navigation links for other options . Your new settings will not
be saved unless your click “Apply Changes” .
setting your Connection Type to Modem only (disable Internet sharing)
In this mode, the Router simply acts as a bridge passing packets across the DSL port . It requires additional software to be installed on your
computers in order to access the Internet .