Belkin N Wireless Modem Router PM01527ea F5D8636-4 - Manual (Page 50)

48
N Wireless Modem Router
sections table of contents 1 2 3 4 5 7 8 9 10 6
UsINg THe Web-based adVaNCed UseR INTeRfaCe
IMPoRTaNT: Make sure your wireless computers are updated
to work with WPA2 and have the correct settings to get proper
connection to the Router .
setting WPa/WPa2-Personal (PsK)
Like WPA security, WPA2 is available in WPA2-Personal (PSK) mode . Typically, WPA2-Personal (PSK) is the mode that will be used in a home
environment . Please refer to the User Manual for more information about wireless security and different types of wireless security .
1 . After you’ve set up your Router, go to the “Security” page under
“Wireless” and select “WPA/WPA2-Personal (PSK)” from the “Security
Mode” drop-down menu .
2 . For “Authentication”, select “WPA-PSK”, “WPA2-PSK”, or “WPA-PSK +
WPA2-PSK” . This setting will have to be identical on the wireless clients
that you set up . “WPA-PSK + WPA2-PSK” mode will allow the Router to
support clients running either WPA or WPA2 security .
3 . For “Encryption Technique”, select “TKIP”, “AES”, or “TKIP+AES” . This
setting will have to be identical on the wireless clients that you set up .
4 . Enter your pre-shared key (PSK) . This can be from eight to 63
characters and can be letters, numbers, or symbols . This same key
must be used on all of the wireless clients that you set up . For example,
your PSK might be something like: “Smith family network key” . Click
“Apply Changes” to finish . You must now set all wireless clients to
match these settings .