Philips SCD530-00 - Manual (Page 10)

6 K = lullaby symbol
7 Q = nightlight symbol
8 T = battery symbol
9 Volume/microphone sensitivity indications:
g = volume off
h = minimum sensitivity/volume
i = maximum sensitivity/volume
Other display indications (not shown):
’High’ = room temperature above temperature set in menu
‘Low’ = room temperature below temperature set in menu
‘Not linked’ = no connection between units*
’Paused’ = lullaby is interrupted
‘Searching’ = units are searching for connection*
‘Linked’ = units are linked*
’Talk’ = talk function is active
* This is only shown on the display of the parent unit.
D Travel pouch
important
Read the user manual carefully before you use the appliance and save it for future reference.
This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
This monitor is not intended to be used as a medical monitor and its use should not replace
adult supervision.
Check if the voltage indicated on the adapter corresponds to the local electrical voltage
before you connect the appliance.
This appliance is suitable for electrical outlet voltages of 10V.
Use and store the appliance at a temperature between 50°F (10°C) and 10°F (0°C).
Do not expose the baby monitor to extreme cold or heat or to direct sunlight.
Make sure the baby unit and power cord are always out of reach of the baby (at least  feet/1
meter away).
Never place the baby unit inside the baby’s bed or playpen.
Never cover the baby monitor with a towel or blanket.
Never immerse any part of the baby monitor in water or any other liquid.
Never use the baby monitor in moist places or close to water.
Except for the battery compartment, do not open the housing of the baby unit and parent
unit in order to prevent electric shock.
Only use the adapters supplied.
The adapters contain a transformer. Do not cut off the adapters to replace them with other
plugs, as this will cause a hazardous situation.
If one of the adapters is damaged, always have it replace with one of the original type in
order to avoid a hazard.
If you place the parent unit next to a transmitter or other DECT appliance (e.g. a DECT
telephone), the connection with the baby unit may be lost.
The temperature and humidity sensor only measures the temperature and humidity in the
baby’s room. It cannot be used to control or adjust the temperature and humidity in the
baby’s room.
The power outlet should be located near the appliance and easily accessible.
-
-
-
-
-
-
-
-
-
-
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
EngliSh 10