Philips SCD530-00 - Manual (Page 18)

Connecting the belt clip
1 Snap the belt clip onto the parent unit (Fig. 33).
Disconnecting the belt clip
1 Pull the belt clip off the parent unit.
Connecting the neck strap
1 Insert the end loop of the neck strap through the hole behind the strap post. Thread the
neck strap through the end loop and pull the neck strap tight (Fig. ).
Disconnecting the neck strap
1 Pass the neck strip through the end loop and pull the end loop out of the hole behind the
strap post.
Cleaning and maintenance
Do not immerse the parent unit or the baby unit in water and do not clean them under the tap.
Do not use cleaning spray or liquid cleaners.
1 Unplug the baby unit if it is connected to an electrical outlet and take the parent unit out of
the charger.
 Clean the parent unit and the baby unit with a damp cloth.
Make sure the parent unit is dry before you put it back into the plugged-in charger.
 Clean the charger with a dry cloth.
 Clean the adapters with a dry cloth.
Note: This appliance has no other user-serviceable parts. For assistance call 1- 800-54-AVENT (1-800-
542-8368).
Storage
When you are not going to use the baby monitor for some time, remove the non-rechargeable
batteries from the baby unit and remove the rechargeable battery pack from the parent unit.
Store the parent unit, the baby unit, the charger of the parent unit and the adapters in the travel
pouch supplied.
Do not wrap cord around the monitor when storing. Store cord in a safe location where it will
not be cut or damaged.
replacement
Baby unit
Batteries
Only replace the non-rechargeable batteries of the baby unit with four 1.5V R6 AA batteries.
Note: We recommend you to use Philips non-rechargeable batteries or an equivalent type.
adapter
Only replace the adapter of the baby unit with an adapter of the original type. For assistance call 1-
800-54-AVENT (1-800-542-8368) or visit our website: www.philips.com/AVENT.
-
-
EngliSh 18