Philips SCD535-00 - Manual (Page 13)

, The LINK light on the parent unit turns green and lights up continuously when a connection
has been established between the baby unit and parent unit. The message ‘Linked’ appears on
the display (Fig. 19).
, After 2 seconds the message ‘Linked’ disappears and the temperature and humidity values
are shown on the display. (Fig. 20)
, The first time you switch on the parent unit, the message ‘Language’ appears on the display.
Select the desired language (see chapter ‘Menu options, section ‘Setting display
language’) (Fig. 21).
, If no connection is established, the LINK light on the parent unit flashes red. The parent
unit beeps from time to time and the message ‘Searching’ appears on the display, followed by
the message ‘Not Linked’ (Fig. 22).
positioning the baby monitor
1 Place the baby unit at least 3.5 feet/1 meter away from your baby (Fig. 23).
2 Place the parent unit within the operating range of the baby unit. Make sure it is at least
3.5 feet/1 meter away from the baby unit to avoid acoustic feedback (Fig. 12).
For more information on the operating range, see section ‘Operating range’ below.
operating range
The operating range of the baby monitor is 1000 feet/330 meters in open air. Depending on the
surroundings and other factors that may cause interference, this range may be smaller. Indoors the
operating range is up to 150 feet/50 meters.
Note: If the ECO mode is switched on, the operating range of the baby monitor is also smaller. See
section ‘ECO mode’ in chapter ‘Menu options’.
Dry materials Material thickness Loss of range
Wood, plaster, cardboard, glass
(without metal, wires or lead)
< 12in/30cm 0-10%
Brick, plywood < 12in/30cm 5-35%
Reinforced concrete < 12in/30cm 30-100%
Metal grilles or bars < 0.4in/1cm 90-100%
Metal or aluminum sheets < 0.4in/1cm 100%
For wet and moist materials, the range loss may be up to 100%.
Features
The following features are described in chapter ‘Menu options’, as they can only be operated in the
menu of the parent unit:
- Adjusting microphone sensitivity
- Sound alert on/off
- Setting room temperature range (minimum and maximum temperature)
- Temperature alert on/off
- Vibration alert on/off
- ECO mode on/off
- Setting temperature scale (Fahrenheit or Celcius)
EngliSh 13