Philips SCD535-00 - Manual (Page 14)

adjusting loudspeaker volume
1 Press the volume + or – button on the baby unit until the desired loudspeaker volume for
the baby unit has been reached (Fig. 24).
2 Press the volume + or – button on the parent unit until the desired loudspeaker volume for
the parent unit has been reached (Fig. 25).
, The displays give visual feedback on the volume settings of the units: (Fig. 26)
1 minimum volume (parent unit and baby unit)
2 maximum volume (parent unit and baby unit)
Note: If the volume is set to the lowest level, the display shows ‘OFF’.
Note: If the volume is set to a high level, the units consume more power.
Talk function
You can use the TALK button on the parent unit to talk to your baby (e.g. to comfort your baby).
1 Press and hold the TALK button and talk clearly into the microphone from a distance of
6-12in/15-30cm (Fig. 27).
, The green LINK light starts flashing and the message ‘Talk’ appears on the display.
2 Release the TALK button when you have finished talking.
Sound level lights
The parent unit continuously monitors the sound level in your baby´s room and the sound level
lights let you know if there is any activity. If your baby cries, you see the sound level lights light up on
the parent unit.
- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are
out.
- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on.
The number of lights that go on is related to the loudness of the sound picked up by the baby
unit.
nightlight
1 Press the nightlight button Qon the baby unit to switch on the nightlight. (Fig. 28)
, Q appears on the display of the parent unit.
2 Press the nightlight button Qagain to switch off the nightlight.
, The nightlight dims gradually before it goes out completely.
, Qdisappears from the display of the parent unit.
Tip: Switch off the nightlight when you operate the baby unit on non-rechargeable batteries. This saves
power.
paging the parent unit
If you have misplaced the parent unit, you can use the PAGE button on the baby unit to locate the
parent unit.
Note: The paging function only works when the parent unit is switched on.
1 Press the PAGE button on the baby unit (Fig. 29).
, The message ‘Paging’ and the paging symbol appear on the displays of the baby unit
and parent unit.
, The parent unit produces a paging alert tone.
2 To stop the paging alert tone, press the PAGE button again or press any button on
the parent unit.
EngliSh 14