OR-Fab 83203 JEEP CHEROKEE XJ 3-PIECE FRONT WINCH BUMPER - Manual (Page 2)

2 ‘84-’01 XJ Front Bumper - Kit 83202, 83203
Before Starting Installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Special tools needed:
a. Die grinder or similar tool capable of cutting
metal and plastic.
b. 7/32” drill bit
5. Park vehicle on a clean, dry, flat, level surface and
block tires so vehicle cannot roll in either direction.
Engine Compartment
1. Disconnect both battery cables. Disconnect nega-
tive cable first, then positive cable.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
NOTE
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover
Positive
Cable
Battery
Negative
Cable
Prepare to Install Kit
Front of Vehicle
1. Bumper
a. 1997-2001 Models: Remove push clips and pull
back wheel well liner from front bumper.
b. 1997-2001 Models: Remove four bolts from
front bumper and two fenders.
c. Disconnect vacuum line from vacuum reservoir.
Wheel Well
Push Clip
Front
Bumper
Fender
Bolts
Front
Bumper
Vacuum
Line
Vacuum
Reservoir
Front
Bumper