Pre - assembly of the wheel carrier – ARB 5650010 User Manual
Page 10
PRE - ASSEMBLY OF THE WHEEL CARRIER
5. INSTALLATION OF THE LOCKING PIN
Place the spring inside the locking bracket
as shown in the photo.
Feed the locking pin through the bracket
and the spring as shown with the upturn of
the locking pin pointing upward.
Using a large flat bladed screwdriver, pull
back the spring as shown and insert the
dowel pin through the slot in the top of the
locking bracket.
Align the dowel pin with the hole in the
locking pin.
Ensure the pin is behind the spring.
Using a hammer, drive the dowel pin
through the hole until it sits flush with the
top surface of the bracket.
Insert Pin Through Slot
Hole In Locking Pin
Last Rev Date: 16/10/2006
Page 10 of 25
3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd