ARB 5650010 - Manual (Page 23)

VEHICLE WIRING MODIFICATIONS FOR HI – LEVEL STOP LAMP
11. DRILLING THE TAIL LAMP
HOUSING
Turn the tail lamp housing upside
down as shown .
Using a 12 mm drill bit , drill a hole in
the bottom of the housing in the centre
on the faint mould line as shown .
Ensure the drill bit does not protrude
to far into the housing when drilling
causing damage to the housing or
wiring .
12. GROMMET AND WIRING TO TAIL
LAMP HOUSING
Push the grommet into the hole in the
tail lamp housing .
Re-fit the tail lamp housing to the
vehicle using the top bolt only at this
stage .
Split the twin core wire and push it
through the grommet into the housing
Allow approx 100mm of the wire
inside the housing .
13. WIRING THE LOOM TO THE TAIL
LAMP
Crimp the ring terminal to the earth
wire ( red with a black trace ) and
place the terminal under the head of
one of the two remaining bolts .
The two remaining bolts can now be
re-fitted to the tail lamp housing as
shown .
Attach the scotch lock to the ( white )
stop lamp positive wire and also secure
the red loom wire – crimp the scotch
lock together as shown .
Feed wiring through grommet
Ring terminal
( Earth )
Housing
Stop lamp
( Positive ) wire
Scotch lock
Grommet
Last Rev Date: 16/10/2006 Page 23 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd