Fitment of wheel carrier to rear bar – ARB 5650010 User Manual
Page 16
FITMENT OF WHEEL CARRIER TO REAR BAR
Last Rev Date: 16/10/2006
Page 16 of 25
3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
4.
FIT WHEEL CARRIER
Assemble the 20 mm pivot bolt with the
bush . The bush when assembled fits into
the top bearing seal and will press against
the bearing.
With assistance, fit the wheel carrier pivot
between the upper and lower pivot plates.
Insert the M20 pivot bolt assembly
through the pivot plates and the top &
bottom bearings.
Align the bolt into the 20 mm lock nut
(installed previously) and - finger tight
only at this stage.
NOTE: - To Aid installation a
15mm – 18 mm rod or aligning pry bar
can be use to centralise the bearings,
spacers and nut so the pivot bolt assy will
pass through all components easily.
5.
TIGHTEN PIVOT BOLT
Tighten of the pivot bolt to preload the
bearings.
Tighten the bolt until the free play has
been removed from the pivot assembly.
Back the bolt off by half a turn once this
has been achieved.
The wheel carrier should now swing freely.
20 mm Pivot Bolt
Bush
Wheel carrier pivot
Wheel carrier frame removed for clarity
Pivot plate