ARB 5650010 - Manual (Page 11)

REINFORCING BRACKET FITMENT TO VEHICLE
6. REINFORCING BRACKET FITMENT
TO CHASSIS. RIGHT HAND SIDE
SHOWN.
Insert an M12 x 90 mm bolt and flat
washer through the chassis reinforcing
bracket as shown. Place an M12 crush tube
over the bolt
Fit the reinforcing bracket against the side
of the chassis rail as shown. Pass the M12
bolt and crush tube through the chassis.
Fasten this bolt using a M12 flat washer,
spring washer and nut.
FOR JEEP UNLIMITED VEHICLES
The hole for the M12 X 90 mm bolt must
be drilled. Mark the position of the hole
using the bracket as a reference. Drill a 13
mm hole through the inner and outer
surfaces of the chassis. Enlarge the hole in
the outer surface of the chassis to 17 mm.
NOTE: Take care when drilling holes not
the damage the fuel tank.
WARNING: Wear eye and ear protection
when using drill.
Insert two M12 x 35 mm tab bolts up
through the access hole in the lower chassis
as shown. Guide the bolt up through the
chassis and through the side hole in the
chassis bracket (the tab on the bolt may
need to be bent to achieve this).
Fasten the bolts using a M12 flat washer,
spring washer and nut.
Make these bolts finger tight only at this
stage. They will be tightened after the rear
bar has been fitted to the vehicle.
REPEAT STEP 6 AS DESCRIBED ABOVE FOR THE LHS OF THE VEHICLE.
M12 x 90 MM BOLT
WITH CRUSH TUBE
RIGHT HAND SIDE SHOWN
Two Tab Bolts
Access Hole In Chassis
Last Rev Date: 16/10/2006 Page 11 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd