ARB 5650010 - Manual (Page 24)

RE-FITTING THE TAIL LAMP TO VEHICLE
14. DIVIDER PLATE TO TAIL LAMP
HOSING
Re - fit the divider to the housing .
Ensure the wiring sits in the cut out
provided on each side at the back .
Note :- The folded edge of the divider
is on the lower side .
On the tail gate where the factory high
level stop lamp loom passes through
there is an exposed hole – Use the
blanking grommet supplied in the
fitting kit to cover it .
15. LENS TO TAIL LAMP
Re – fit the tail lamp lens to the
housing .
With the wheel carrier door open ,
trim the remaining end of the
convolute tubing to sit under the tail
lamp as shown .
Check that the high level brake lamp
is operational and the loom is tie to the
frame securely ( step 10 ) and does not
hang in the pivot area .
16. RE - FIT THE SPARE WHEEL
Re-fit the spare wheel using the wheel
nuts provided.
Locking wheel nuts are available as an
accessory from your ARB stockist .
( part number 575 0040 ) .
A Hi-Lift jack mounting bracket is
available as an accessory from your
ARB stockist ( part number 575 0030 ).
Cut out in divider
Last Rev Date: 16/10/2006 Page 24 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd