ARB 5650010 - Manual (Page 15)

FITMENT OF WHEEL CARRIER TO REAR BAR
1. REMOVE RIGHT HAND TAIL LIGHT
The right hand tail light lens and housing
will need to be removed as shown , to allow
the pivot bolt (as per step 4 ) to be aligned
and fitted . Remove the lens from the
housing , remove the divider plate that
separates the two lower bulbs from the
housing to access the three housing
retaining bolts – remove as shown .
Tie or tape the housing out of the way to
prevent damage to the tail light housing or
the vehicle.
2.
FIT PIVOT LOCK NUT
(fitted up from the underside )
Insert the M20 pivot lock nut below the
lower pivot plate as shown.
Position the nut so that it is central with
the hole on the lower pivot plate.
3.
INSERT PIVOT SPACER
Cover both the top and bottom seals and
bearing hubs with a liberal amount of
grease. This will help waterproof the hub
and aid with assembly. It will also hold the
spacer into the hub as covered in the next
step.
Insert a 9 mm spacer up into the underside
of the hub of the wheel carrier as shown in
the photo (the grease will hold it in
position). Push the spacer up through the
seal.
Place the other 9 mm spacer into the lower
hole of the rear bar shell as shown.
Housing retaining bolts
RIGHT HAND SIDE OF BAR
9 mm Spacers
Last Rev Date: 16/10/2006 Page 15 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd