ARB 5650010 - Manual (Page 12)

FITTING THE REAR BAR TO THE VEHICLE
7. INSTALLATION OF THE REAR BAR
TO THE VEHICLES REAR
CROSS MEMBER.
With the assistance of another person lift
the rear bar into position and fit to the
back of the vehicle.
Slide the bar forward on the vehicle until
the uprights touch the rear cross member.
8.
POSITIONING OF REAR BAR
ON VEHICLE.
Align the holes in the rear bar so that the
holes line up with the holes in the base of
the chassis.
There should be equal spacing between the
wing and quarter panel on both sides of
the vehicle.
RIGHT HAND SIDE SHOWN
LEFT HAND SIDE SHOWN
9. ALIGN REAR BAR ON VEHICLE
Align the rear bar so that the gap between
the body and rear bar is parallel and level.
Insert two M12 x 40 mm bolts & flat
washer through the front of the bar as
shown.
Fasten these bolts with M12 flat washers,
spring washers and nuts.
NOTE: The bolts will pass through the
rear bar, the chassis cross member and the
chassis reinforcing bracket.
Do not tighten these bolts, as the rear bar
will be removed temporally after step 10.
Vehicle Cross Member
Rear Bar
Last Rev Date: 16/10/2006 Page 12 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd