Apple Aperture 3.5 - Manual (Page 330)

Chapter 7 Make image adjustments 330
Apply an effect to an image
When you apply an effect to an image, the adjustment controls and parameter values update to
reflect the settings saved in the effect. If you prefer, you can use an effect as a starting point in
your image adjustment workflow and then fine-tune the effect after it’s applied to the image.
1 Select a photo.
2 In the Adjustments inspector or the Adjustments pane of the Inspector HUD, do one of
the following:
•
To apply an effect in addition to any previously applied adjustments: Choose the effect you want
to apply to the image from the Effects pop-up menu.
Note: When you place the pointer over an effect in the Effects pop-up menu, a preview of the
adjustment applied to the image appears to the right of the highlighted effect.
Place the pointer over
an effect to preview its
effect on the photo.
•
To replace any previously applied adjustments with an effect: Hold down the Option key while
choosing the effect from the Effects pop-up menu.
67% resize factor