Synergy 5221 - 07-10 Jeep JK 2/4 Door Front Cage Kit User Manual
Page 30
Advertising
42. Remove the A-pillar assembly from the vehicle and fully weld the tube to the floor
plate outside of the Jeep as it is much easier to fully weld when not installed in the
vehicle.
43. Allow welds to cool and paint the entire A-pillar to the desired color with the
exception of the top joint which still needs to be welded to the Jeep’s cage.
44. Before reinstalling the A-pillar into the vehicle, prepare the notch area on the Jeep for
welding. See image 43.1 below.
45. Bolt the A-pillar back to the floor and tack into place once satisfied with fitment. Do
not fully weld at this time. Repeat A-pillar fitment on the passenger side. Steps 46-
Advertising