Synergy 5221 - 07-10 Jeep JK 2/4 Door Front Cage Kit User Manual
Page 5
8. If you are using a rear cage kit, install that section now per the instructions included
in that kit.
9. Next, install the A-pillar floor plates by removing the floor side trim and pulling up
the carpet to access the bare floor. Position the floor plate as shown. Note, the floor
plate in the image below is of a pre-production unit, the production pieces have a
longer angled flange on the front edge to cover up the hole in the floor which
becomes exposed after removing the plug showed in image 9.1.
Image 9.1; Floor grommet that must be removed for floor plate to be installed.
10. With floor plug / grommet removed. Position the floor plate as shown. The outer
edge should be as far to the outside as possible and touch the side of the Jeep kick
panel. Mark and punch the 5 mounting holes using a transfer punch or similar tool.