JLG 260MRT Operator Manual - Manual (Page 34)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3-2 – JLG Lift – 3121219
3.3 CONTROLS AND INDICATORS
(Refer to Figure 3-1.)
The machine is equipped with control panels that use sym-
bols instead of words to indicate control functions.
Ground Control Station
DO NOT OPERATE FROM GROUND CONTROL STATION WITH PERSON-
NEL IN THE PLATFORM EXCEPT IN AN EMERGENCY.
PERFORM AS MANY PRE-OPERATIONAL CHECKS AND INSPECTIONS
FROM THE GROUND CONTROL STATION AS POSSIBLE.
NOTE: When the machine is shut down for overnight parking or
battery charging, the EMERGENCY STOP and POWER
SELECTOR switches must be positioned to OFF to pre-
vent draining the batteries.
1. Power Selector Switch - A three position, key-operated
power selector switch supplies operating power to the
platform or ground controls, as selected. When posi-
tioned to platform, the switch provides power to the
emergency stop switch at the platform controls. When
positioned to ground, the switch provides power to the
emergency stop switch at the ground controls. With the
power selector switch in the center off position, power is
shut off to both platform and ground controls and the
key can be removed to disable the machine.
NOTE: With the Power Selector switch in the off position, the key
can be removed in order to incapacitate the machine on
the jobsite to avoid unauthorized use of the machine.
With the POWER SELECTOR switch positioned to
GROUND, ground functions will operate at low speed at
all times.
NOTE: Low speed is the default speed for all functions. When the
platform is elevated, all functions operate in creep speed
only.
2. Latch - Allows box to be opened and closed.
3. Circuit Breaker - This 10 Amp circuit breaker, located on
the left side of the platform control box, restores inter-
rupted power to the platform controls.
4. Alternator LED - Illuminates when the alternator drops
below a pre-set level.
5. Oil Pressure LED - Illuminates when the engine oil pres-
sure drops below 7 psi (0.48 bar).