JLG 260MRT Operator Manual - Manual (Page 54)

SECTION 4 - MACHINE OPERATION
4-4 – JLG Lift – 3121219
Manual Level Adjustment (Trim)
NOTE: There is an override feature on the Leveling Jack system
that allows the operator to adjust (trim) the level of the
machine to the left or right when the platform is com-
pletely lowered. Use the following instructions to adjust
the level of the machine.
6. With the machine in the stowed position turn the power
on, start machine and depress the leveling jack selec-
tion switch located on the front of the platform control
box.
7. To adjust (trim) the machine to the right, activate the
steer switch on the top of the controller to the right until
the desired position is reached.
8. To adjust (trim) the machine to the left, activate the steer
switch on the top of the controller to the left until the
desired position is reached.
NOTE: Anytime the trim function is used there is a possibility that
the machine may become out of level. At this time the
machine will no longer lift but the machine can be low-
ered.
NOTE: The machine must be in the stowed position before the
trim function is operable.
4.4 PLATFORM
Raising
DO NOT RAISE PLATFORM EXCEPT ON A SMOOTH, FIRM, AND LEVEL
SURFACE, FREE OF OBSTRUCTIONS AND HOLES.
1. If the machine is shut down, place the power selector
switch to desired position (platform or ground).
2. Position the applicable emergency stop Switch to the on
position.
3. If operating from the ground controls, position the lift
switch to up and hold until desired elevation is achieved.
If operating from the platform controls, press the enable
switch then position the lift switch to up and hold until
desired elevation is reached. The lift switch is part of the
enable circuit, which supplies power to the lift switch for
3 seconds after the enable switch is pressed. If the lift
switch is not activated within 3 seconds after the enable
switch is pressed, power is removed from the circuit and
the enable switch must be pressed again before activat-
ing the lift switch.