JLG 260MRT Operator Manual - Manual (Page 42)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3-10 – JLG Lift – 3121219
Indicator Panel LED’s
(Refer to Figure 3-4.)
1. Drive - This LED will illuminate when the drive select but-
ton is activated.
2. Lift - This LED will illuminate when the lift select button is
activated.
3. Fuel Gauge - This series of LED’s give the operator a
visual of the amount of fuel remaining.
4. Tilt Alarm Warning Light - This red warning light on the
control panel will illuminate when the chassis is on a
severe slope.
5. Engine/Filter Distress Light - This warning light, when
illuminated, warns the operator of an engine or hydraulic
system fault condition. A bank of warning lights, located
at the ground control station, indicates the specific fault
condition to the operator. The indicator lights are: Alter-
nator, Charge Pressure, Engine Temperature, Oil Pres-
sure, and Return Filter.
6. Leveling Jacks (retracted) - This set of lights will illumi-
nate once all the leveling jacks are retracted.
7. Leveling Jacks (extended) - This set of lights will illumi-
nate once all the leveling jacks are extended.
FOR MACHINES EQUIPPED WITH THE YANMAR DIESEL ENGINE, THE
TIMER RELAY MUST SEAT THE FUEL SOLENOID WITH ITS INITIAL
PULSE, OR THE ENGINE WILL NOT START. PROLONGED NO-START IS
AN INDICATION THAT THE FUEL SOLENOID HAS NOT SEATED OR THAT
THERE IS NO FUEL. IF THE ENGINE FAILS TO START, THE START
SWITCH MUST BE RE-CYCLED TO PULSE THE FUEL SOLENOID INTO
THE SEATED POSITION.
IF TILT ALARM IS ON WHEN PLATFORM IS RAISED, LOWER PLATFORM
COMPLETELY, THEN REPOSITION MACHINE SO THAT IT IS LEVEL
BEFORE RAISING PLATFORM.
DO NOT OPERATE MACHINE IF HIGH DRIVE SPEED OPERATES WHEN
PLATFORM IS RAISED ABOVE THE STOWED POSITION.