JLG 260MRT Operator Manual User Manual
Page 75
SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3121219
– JLG Lift –
6-9
TO AVOID PERSONAL INJURY, USE SAFETY PROP FOR ALL MAINTE-
NANCE REQUIRING PLATFORM TO BE ELEVATED.
NOTE: Be sure to lubricate like items on each side
NOTE: Recommended lubricating intervals are based on
machine operations under normal conditions. For
machines used in multi-shift operations and/or exposed to
hostile environments or conditions, lubrication frequen-
cies must be increased accordingly.
Operate hydraulic functions through one complete cycle
before checking hydraulic oil level in tank. Oil should be
visible in ADD sight window on hydraulic tank. If oil is not
visible, add oil until oil is visible in both ADD and FULL
sight windows on tank. Do not overfill tank.
NOTE: The following numbers correspond to those in Figure 6-
1. Hydraulic Oil
Lube Point - Fill Level/Drain Plug
Lube - HO
Interval - Check oil every 10 hours of operation; change
oil every 2 years or 1200 hours of operation.
2. Hydraulic Filter Element
Interval - Initial change 40 hours, every 250 hours of
operation thereafter.
3. Engine Compartment
a. Engine Oil Check/Fill
Capacity - See Engine Manual
Lube - See Engine Manual
Interval - Check level daily; change per manufac-
turer’s engine manual.
b. Air Cleaner
Lube Point - Filter Element
Interval - Check every 3 months or 150 hours;
change every 6 months or 300 hours.
c. Fuel Filter
Lube Point - Filter Element
Interval - Clean every 3 months or 150 hours;
change every 6 months or 300 hours.
4. Sliding Wear Pads
Lube Points - 8 Sliding Wear Pads
Lube - MPG
Interval - Every month or 50 hours.
5. Drive Hub
Lube Point - Fill Plug
Lube - EPGL
Interval - Every 2 years or 1200 hours