JLG X600AJ Operator Manual - Manual (Page 62)

SECTION 4 - MACHINE OPERATION
4-12 – JLG Lift – 3121637
If the functions are selected when one of the above listed
conditions is missing, an error message will appear on the
platform/remote control display indicating which of the
conditions are OK and which are not. If the condition is that
an outrigger is not set properly, the message will also indi-
cate which outrigger is not set properly.
ST1: if OK outrigger 1 is set properly.
ST2: if OK outrigger 2 is set properly.
ST3: if OK outrigger 3 is set properly.
ST4: if OK outrigger 4 is set properly.
INCL: if OK the machine is set up on an accepted slope.
LOAD: if OK the load in the platform is acceptable.
PLATFORM: if OK the platform/remote control box is in the
proper location in the platform.
PEDAL: If OK the footswitch is correctly depressed.
AUTOST: when using the auto stabilizer set button 7, if OK,
stabilizers are set properly.
If NO, button 7 was released before tilt sensor detected
machine was level and stabilizers were not set properly.