JLG X600AJ Operator Manual - Manual (Page 64)

SECTION 4 - MACHINE OPERATION
4-14 – JLG Lift – 3121637
IF ONE OF THE ORANGE LIGHTS LOCATED ON EACH OUTRIGGER SHOULD
REMAIN ON WHEN THAT OUTRIGGER IS LIFTED FROM THE GROUND,
STOP THE MACHINE IMMEDIATELY AND CALL A QUALIFIED JLG SERVICE
TECHNICIAN AS THIS INDICATES A PROBLEM WITH THE CORRESPOND-
ING OUTRIGGER MICRO SWITCH.
IF THE SLOPE EXCEEDS 12°, THE MACHINE IS NOT CAPABLE OF PROPERLY
SETTING THE OUTRIGGERS AND LEVELING ITSELF. OPERATION OF THE
BOOM AND PLATFORM FUNCTIONS WILL NOT BE ALLOWED IN THIS CON-
DITION. THE MACHINE IS CONSIDERED STABILIZED WHEN LEVELED TO
LESS THAN 1° AND THE TRACKS ARE LIFTED AT LEAST 2 IN. (5 CM) FROM
THE GROUND.
STABILIZING THE MACHINE WITH AN INCLINATION DEGREE HIGHER
THAN THE ONE ALLOWED COULD CAUSE INSTABILITY OF THE MACHINE
If the platform ladder is higher than 16 in. (40 cm) off the
ground when the ladder is lowered, when setting the
machine on outriggers from the ground position, lower the
outriggers until the ladder is less than 16 in. (40 cm) off the
ground. Then enter the platform to properly set the machine
up on outriggers.
Retracting The Outriggers
(Reference Figure 4-4. for item numbers)
Either - Press and hold button no. 1 (item
1) of the remote control.
The 4 outriggers will all retract at the same
time and lower the machine.
or
Operate each outrigger separately by
pressing button 2 (item 2) to select which
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal at each outrigger,
each press of button 2 displays the outrigger
selected on the LCD display). Press button 1
(item 1) to retract or button 7 (item 7) to set
that outrigger.
Note: To cycle back to outrigger auto-
retract mode, press button 2 (item 2) until
the LCD display shows the normal operating
icons.
AUTO
1
MANUAL
SELECT
2