JLG X600AJ Operator Manual - Manual (Page 8)

TABLE OF CONTENTS
ii – JLG Lift – 3121637
SECTION - PARAGRAPH, SUBJECT PAGE SECTION - PARAGRAPH, SUBJECT PAGE
Electric Engine Starting Procedure -
AC Voltage Machine . . . . . . . . . . . . . . . . . . . . . . . . . . 4-3
Electric Engine Starting Procedure -
LITHIUM-ION Machine . . . . . . . . . . . . . . . . . . . . . . . . 4-4
4.4 BASE AND BOOM/JIB ALIGNMENT . . . . . . . . . . . . . . 4-6
4.5 TRACKS - DRIVING, STEERING AND TRACK
WIDTH ADJUST. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Track width adjust . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Travelling (Drive and Steer) . . . . . . . . . . . . . . . . . . . 4-7
Travelling (Grades and Side Slopes) . . . . . . . . . . . 4-7
Jib Position for Travelling . . . . . . . . . . . . . . . . . . . . 4-10
4.6 OUTRIGGER OPERATION . . . . . . . . . . . . . . . . . . . . . . . 4-11
Setting Outriggers From the Platform/
Remote Console . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-13
Retracting The Outriggers . . . . . . . . . . . . . . . . . . . 4-14
4.7 BOOM/PLATFORM OPERATION . . . . . . . . . . . . . . . . 4-15
Overload Alarm. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-15
Engine Pre-Heat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-15
Platform Level Adjustment. . . . . . . . . . . . . . . . . . . 4-15
Raise And Lower The Tower Boom . . . . . . . . . . . 4-17
Raise And Lower The Main Boom. . . . . . . . . . . . . 4-17
Telescope The Main Boom . . . . . . . . . . . . . . . . . . . 4-17
Platform Rotation. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-17
Raise And Lower The Jib . . . . . . . . . . . . . . . . . . . . . 4-17
4.8 PLATFORM REMOVAL/INSTALLATION . . . . . . . . . . 4-19
4.9 BATTERY CHARGING - GAS/AC-ELECTRIC . . . . . . . 4-20
Battery Charging - Daily. . . . . . . . . . . . . . . . . . . . . . 4-20
4.10 BATTERY CHARGING - LITHIUM-ION MACHINE . .4-21
Charging the Battery Pack . . . . . . . . . . . . . . . . . . .4-21
Charge Curve. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-23
4.11 SHUT DOWN AND PARK . . . . . . . . . . . . . . . . . . . . . . .4-23
4.12 LIFTING AND TIE DOWN . . . . . . . . . . . . . . . . . . . . . . .4-25
Lifting - Outrigger Lifting Rings . . . . . . . . . . . . . .4-25
Lifting - Fork Lift Pockets . . . . . . . . . . . . . . . . . . . . . 4-27
Loading and Unloading the Machine on
Transport Vehicles Using Ramps . . . . . . . . . . . . .4-28
Tie Down . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-29
4.13 MACHINE DECALS . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-31
SECTION - 5 - EMERGENCY PROCEDURES
5.1 GENERAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
5.2 INCIDENT NOTIFICATION . . . . . . . . . . . . . . . . . . . . . . . 5-1
5.3 EMERGENCY OPERATION . . . . . . . . . . . . . . . . . . . . . . . 5-1
Power Main Cut-Off Switch Location . . . . . . . . . . 5-1
Operator Unable to Control Machine . . . . . . . . . . 5-2
Platform or Boom Caught Overhead. . . . . . . . . . . 5-2
Manual Descent with Engine Running and
Electrical Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
Manual Descent with Engine Running but
without Electrical Power . . . . . . . . . . . . . . . . . . . . . . 5-6
Manual Descent without Engine and
Electrical Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7
Outrigger/Track Movement Emergency
Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-9