JLG 600SC_660SJC Operator Manual - Manual (Page 35)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121156 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: This machines is equipped with control panels that use
symbols to indicate control functions. Refer to decal
located on the control box guard in front of the control box
or by the ground controls for these symbols and the corre-
sponding functions.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CON-
TROL LEVERS OR TOGGLE SWITCHES CONTROLLING PLATFORM
MOVEMENT DO NOT RETURN TO THE OFF POSITION WHEN RELEASED.
Ground Control Station
(See Figure 3-1., Ground Control Station - 600SC, and Figure
3-2., Ground Control Station - 660SJC)
NOTE: If equipped, the Function Enable switch must
be held down in order to operate Telescope,
Swing, Lift, Jib Lift, Platform Level Override,
and Platform Rotate functions.
1. Platform Rotate
A three position switch permits rotation of the platform.